Category | Formula One | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
Constructor | Lotus | ||||||||||
Designer(s) | Gérard Ducarouge (Technical Director) Martin Ogilvie (Chief Designer) Bernard Dudot (Chief Engine Designer (Renault)) | ||||||||||
Predecessor | 97T | ||||||||||
Successor | 99T | ||||||||||
Technical specifications[1] | |||||||||||
Chassis | Carbon fibre and Kevlar Aluminium honeycomb monocoque | ||||||||||
Suspension (front) | Double wishbones, pull-rod actuated coil springs over dampers, anti-roll bar | ||||||||||
Suspension (rear) | Double wishbones, pull-rod actuated coil springs over dampers, anti-roll bar | ||||||||||
Axle track | Front: 1,816 mm (71.5 in) Rear: 1,620 mm (64 in) | ||||||||||
Wheelbase | 2,720 mm (107 in) | ||||||||||
Engine | Renault Gordini EF15B, 1,492 cc (91.0 cu in), 90° V6, turbo, mid-engine, longitudinally-mounted | ||||||||||
Transmission | Lotus / Hewland 6-speed manual | ||||||||||
Power | 800-900 hp (race-spec),[2] 1,000-1,200+ hp (qualifying-trim)[3] @ 12,500 rpm | ||||||||||
Weight | 540 kg (1,190 lb) | ||||||||||
Fuel | Elf | ||||||||||
Tyres | Goodyear | ||||||||||
Competition history | |||||||||||
Notable entrants | John Player Team Lotus | ||||||||||
Notable drivers | 11. Johnny Dumfries 12. Ayrton Senna | ||||||||||
Debut | 1986 Brazilian Grand Prix | ||||||||||
| |||||||||||
Constructors' Championships | 0 | ||||||||||
Drivers' Championships | 0 |
The Lotus 98T was a Formula One car designed by Gérard Ducarouge and Martin Ogilvie and built by Team Lotus for use in the 1986 Formula One World Championship. Development of the previous year's 97T, the car was raced by Brazilian Ayrton Senna, in his second year with the team, and Scottish newcomer Johnny Dumfries.
The chassis featured a lower monocoque than the 97T as a result of a regulation change stipulating a reduction in fuel capacity to 195 litres. The powertrain consisted of the new Renault EF15B turbocharged V6 engine, driving through a six-speed, manual transmission by Hewland.[4]
The EF15B was to appear in two forms, the standard engine and the "D.P." engine which featured pneumatic valve springs for the first time. At the end of the season Renault introduced the revised EF15C which in addition to the D.P. valve gear also boasted common rail fuel injection and much-revised water cooling through the cylinder head reducing the likelihood of pre-ignition (detonation). Power figures for this period of F1 history are largely speculative as most engine manufactures freely admitted that their testbeds would not have a sufficient power rating to measure the 1.5-litre turbo's output at above 4-bar boost. It is claimed that the Renault EF15B in its pinnacle increment was claimed to produce in excess of 1000 HP at unrestricted boost pressure, thus making it one of the most powerful engines ever used in Formula 1 history. [4]
This was, however, during qualifying, where teams used unrestricted boost pressures for maximum power output, and for very quick lap times. These qualifying spec. engines , thanks to the unrestricted boost were pushed to their absolute structural limits and would only last about a couple of clean laps. There were also engines set up for races, and these produced around 900 HP in this trim, which was about the maximum the engine could cope with over a race distance.[5] The 98T was also the final Lotus powered by a Renault engine, as Lotus switched to Honda for the following year/season.
The gearbox came in two variants, a conventional five-speed, and a new six-speed. The six-speed was very much a development gearbox and was largely unreliable. While Senna opted to run only with the five-speed, Dumfries was tasked with testing the six-speed. Both gearboxes featured Hewland internals within a Lotus designed casing.[6]
Other notable innovations of the 98T included a two-stage ride height adjustment, water injection through the intercoolers, an early form of barge board (also present on the 97T), and an advanced (for the time) fuel consumption microcomputer.