X86 memory segmentation

This article needs additional citations for verification. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "X86 memory segmentation" – news · newspapers · books · scholar · JSTOR (June 2017) (Learn how and when to remove this message)

The Intel x86 computer instruction set architecture has supported memory segmentation since the original Intel 8086 in 1978. It allows programs to address more than 64 KB (65,536 bytes) of memory, the limit in earlier 80xx processors. In 1982, the Intel 80286 added support for virtual memory and memory protection; the original mode was renamed real mode, and the new version was named protected mode. The x86-64 architecture, introduced in 2003, has largely dropped support for segmentation in 64-bit mode.

In both real and protected modes, the system uses 16-bit segment registers to derive the actual memory address. In real mode, the registers CS, DS, SS, and ES point to the currently used program code segment (CS), the current data segment (DS), the current stack segment (SS), and one extra segment determined by the programmer (ES). The Intel 80386, introduced in 1985, adds two additional segment registers, FS and GS, with no specific uses defined by the hardware. The way in which the segment registers are used differs between the two modes.^[1]

The choice of segment is normally defaulted by the processor according to the function being executed. Instructions are always fetched from the code segment. Any stack push or pop or any data reference referring to the stack uses the stack segment. All other references to data use the data segment. The extra segment is the default destination for string operations (for example MOVS or CMPS). FS and GS have no hardware-assigned uses. The instruction format allows an optional segment prefix byte which can be used to override the default segment for selected instructions if desired.^[2]