![]() | |||
Type | Serial communication bus | ||
---|---|---|---|
Production history | |||
Designer |
MIPI Alliance Sensor Working Group | ||
Designed | 2016 | ||
Manufacturer | Intel Corporation; Lattice Semiconductor | ||
Hot pluggable | Yes | ||
Electrical | |||
Signal | CMOS | ||
Data | |||
Data signal | Open-drain or Push/Pull | ||
Width | 2 wires [data + clock] | ||
Bitrate |
12.5 Mbit/s (SDR, standard),
25 Mbit/s (DDR),
33 Mbit/s (ternary),
| ||
Protocol | Serial, half-duplex |
I3C, also known as SenseWire,[1][2] is a specification[3] to enable communication between computer chips by defining the electrical connection between the chips and signaling patterns to be used. Short for "Improved Inter Integrated Circuit",[4] the standard defines the electrical connection between the chips to be a two wire, shared (multidrop), serial data bus, one wire (SCL
) being used as a clock to define the sampling times, the other wire (SDA
) being used as a data line whose voltage can be sampled. The standard defines a signalling protocol in which multiple chips can control communication and thereby act as the bus controller.
The I3C specification takes its name from, uses the same electrical connections as, and allows some backward compatibility with, the I²C bus, a de facto standard for inter-chip communication, widely used for low-speed peripherals and sensors in computer systems. The I3C standard is designed to retain some backward compatibility with the I²C system, notably allowing designs where existing I²C devices can be connected to an I3C bus but still have the bus able to switch to a higher data rate for communication at higher speeds between compliant I3C devices. The I3C standard thereby combines the advantage of the simple, two wire I²C architecture with the higher communication speeds common to more complicated buses such as the Serial Peripheral Interface (SPI).
The I3C standard was developed as a collaborative effort between electronics and computer related companies under auspices of the Mobile Industry Processor Interface Alliance (MIPI Alliance). The I3C standard was first released to the public at the end of 2017,[5][6] although access requires the disclosure of private information. Google and Intel have backed I3C as a sensor interface standard for Internet of things (IoT) devices.[7]