 | This article needs additional citations for verification. (August 2010) |
Memory-mapped I/O (MMIO) and port-mapped I/O (PMIO) are two complementary methods of performing input/output (I/O) between the central processing unit (CPU) and peripheral devices in a computer (often mediating access via chipset). An alternative approach is using dedicated I/O processors, commonly known as channels on mainframe computers, which execute their own instructions.
Memory-mapped I/O uses the same address space to address both main memory[a] and I/O devices.[1] The memory and registers of the I/O devices are mapped to (associated with) address values, so a memory address may refer to either a portion of physical RAM or to memory and registers of the I/O device. Thus, the CPU instructions used to access the memory (e.g. MOV ...) can also be used for accessing devices. Each I/O device either monitors the CPU's address bus and responds to any CPU access of an address assigned to that device, connecting the system bus to the desired device's hardware register, or uses a dedicated bus.
To accommodate the I/O devices, some areas of the address bus used by the CPU must be reserved for I/O and must not be available for normal physical memory; the range of addresses used for I/O devices is determined by the hardware. The reservation may be permanent, or temporary (as achieved via bank switching). An example of the latter is found in the Commodore 64, which uses a form of memory mapping to cause RAM or I/O hardware to appear in the 0xD000–0xDFFF range.
Port-mapped I/O often uses a special class of CPU instructions designed specifically for performing I/O, such as the in and out instructions found on microprocessors based on the x86 architecture. Different forms of these two instructions can copy one, two or four bytes (outb, outw and outl, respectively) between the EAX register or one of that register's subdivisions on the CPU and a specified I/O port address which is assigned to an I/O device. I/O devices have a separate address space from general memory, either accomplished by an extra "I/O" pin on the CPU's physical interface, or an entire bus dedicated to I/O. Because the address space for I/O is isolated from that for main memory, this is sometimes referred to as isolated I/O.[2] On the x86 architecture, index/data pair is often used for port-mapped I/O.[3]
Cite error: There are <ref group=lower-alpha> tags or {{efn}} templates on this page, but the references will not show without a {{reflist|group=lower-alpha}} template or {{notelist}} template (see the help page).