New York State Route 195

This article is about the most recent alignment of NY 195, removed in 1980. For the former alignment of NY 195 in Essex County, see New York State Route 9N.

New York State Route 195 marker
New York State Route 195
Map
Map of Franklin and St. Lawrence counties with NY 195 highlighted in red
Route information
Maintained by NYSDOT
Length6.20 mi[1] (9.98 km)
Existedc. 1938[2][3]–April 10, 1980[4]
Major junctions
South end NY 11B in Lawrence
North end US 11 in Lawrence
Location
CountryUnited States
StateNew York
CountiesSt. Lawrence
Highway system
← NY 194→ NY 196

New York State Route 195 (NY 195) was a 6.20-mile (9.98 km) long north–south state highway located within the town of Lawrence in St. Lawrence County, New York, in the United States. The southern terminus of the route was at NY 11B in the hamlet of Nicholville. Its northern terminus was at U.S. Route 11 (US 11) in the community of Lawrenceville. NY 195 was located in an extremely rural portion of the county and had only three intermediary intersections with other through traffic roads.

NY 195 was first a piece of the former Route 30, a legislative route designated by the state in 1908. The route was replaced in 1924, by NY 2, the first set of signed state routes in New York, with a bypassed section near Lawrenceville being designated as NY 2A about two years later. NY 2 and NY 2A were decommissioned in 1927 for US 11, leaving the route unnumbered for a few years. In the 1930 state highway renumbering, the Nicholville–Lawrenceville route was designated as NY 11B. By 1938, NY 11B was realigned to Malone, and the route was replaced by NY 195. The route was officially decommissioned by the New York State Department of Transportation on April 10, 1980, but the route remained under state control for two more years, until September 1, 1982, when the alignment was turned over to St. Lawrence County and designated as County Route 55 (CR 55) and County Route 54 (CR 54).

  1. ^ Cite error: The named reference inventory was invoked but never defined (see the help page).
  2. ^ Cite error: The named reference 1937map was invoked but never defined (see the help page).
  3. ^ Cite error: The named reference 1938map was invoked but never defined (see the help page).
  4. ^ Cite error: The named reference 2009log was invoked but never defined (see the help page).