Romney Lock

Romney Lock
Romney Lock from downstream
Map
WaterwayRiver Thames
CountyBerkshire
Maintained byEnvironment Agency
OperationHydraulic
First built1798
Latest built1980
Length78.50 m (257 ft 7 in) [1]
Width7.45 m (24 ft 5 in)[1]
Fall2.01 m (6 ft 7 in)[1]
Above sea level60 feet (18 m)
Distance to
Teddington Lock
23 miles (37 km)
Power is available out of hours
Romney Lock
River Thames
Clewer Mill Stream
Boveney Lock
(and boat rollers)
Race Course Yacht Basin
Site of old mill
Cuckoo Weir
A332 Queen Elizabeth Bridge
-- (Windsor & Eton Bypass)
Windsor Railway Bridge
Baths Island
Deadwater Ait
Firework Ait
Windsor Bridge
moorings
Site of old mill
weir
Romney Lock
Jubilee River
-- (from Boulter's Lock)
Black Potts Railway Bridge
River Thames

Romney Lock is a lock on the River Thames in England near Windsor and Eton, about half a mile downstream of Windsor Bridge. It is on the Windsor side of the river next to a boatyard and adjoins Romney Island, a long strip-shaped ait in the middle of the river. The first lock was built by the Thames Navigation Commission in 1798.

The weir is some distance upstream near the end of Romney Island and runs across the river to Cutlers Ait. A small 200kW hydroelectric generation station was installed in 2011 to supply electricity to Windsor Castle.[2][3]

  1. ^ a b c "Environment Agency Dimensions of locks on the River Thames". web page. Environmental Agency. 8 November 2012. Retrieved 18 November 2012. Dimensions given in metres
  2. ^ Proposals for hydro power scheme
  3. ^ The Queen demonstrates her power Daily Telegraph, 23 November 2013