Rubber tapping

Rubber tapping in Indonesia, 1951

Rubber tapping is the process by which latex is collected from a rubber tree. The latex is harvested by slicing a groove into the bark of the tree at a depth of one-quarter inch (6.4 mm) with a hooked knife and peeling back the bark. Trees must be approximately six years old and six inches (150 mm) in diameter in order to be tapped for latex.[1][better source needed]

Rubber tapping is not damaging to the forest, as it does not require the tree to be cut down in order for the latex to be extracted. Jungle rubber is essentially old secondary forest, strongly resembling the primary forest. Its species' richness is about half that of the primary forest. Michon and de Foresta (1994) found that sample jungle rubber sites contained 92 tree species, 97 lianas, and 28 epiphytes compared with 171, 89, and 63, respectively, in the primary forest, and compared with 1, 1, and 2 in monoculture estates. Thiollay (1995) estimated that jungle rubber supports about 137 bird species, against 241 in the primary forest itself. Jungle rubber is expected to resemble primary forest in its hydrological functions.[2] Mono culture rubber tree plantations have far less of an environmental impact than other crops, such as coffee or especially oil palm.

  1. ^ Hays, Jeffrey. "Rubber and the Rain Forest". Facts and Details. Retrieved 8 June 2020.
  2. ^ Chomitz, Kenneth M.; Griffiths, Charles (May 1996). "Deforestation, shifting cultivation, and tree crops in Indonesia: nationwide patterns of smallholder agriculture at the forest frontier" (PDF). World Bank. Archived from the original (PDF) on 15 July 2007 – via archive.org.