TVR Speed Twelve engine

This article needs additional citations for verification. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "TVR Speed Twelve engine" – news · newspapers · books · scholar · JSTOR (April 2018) (Learn how and when to remove this message)

The TVR Speed Twelve engine is the name of a V12 engine manufactured by TVR for use in the TVR Speed 12 race car, and later the TVR Cerbera Speed Twelve road car.^[2]

The engine was developed by essentially joining two Speed Six engine blocks to a common crankshaft. However it featured a revised cylinder head design with bucket valve actuation in place of the Speed Six's finger follower system. The completed engine displaced 7.7 litres and was originally developed for racing applications in TVR's Speed Twelve. Later on, a version was developed for the prototype of a road car to be called the Cerbera Speed Twelve.

Unusually for an automobile, the Speed Twelve's engine block was not constructed of cast iron or aluminum alloy, but rather of welded steel construction.^[3]

The racing version of the engine produced approximately 675 bhp (503 kW) with its power limited by the intake restrictors required by racing regulations. For the road-version of the engine, the restrictors were not needed so the engine was developed without them. According to reports from TVR engineers, the de-restricted engine snapped the central shaft of their 1,000 bhp (746 kW)-rated dynamometer during the bench-test. The engine's output was later estimated at 960 bhp (716 kW), though the official figure given by TVR was 800 bhp (597 kW).^[1] When the prototype vehicle was road-tested by then-owner Peter Wheeler, he reportedly concluded that the vehicle was too powerful to be practical and the project was scrapped.