Talk:Differential pulse-code modulation

This article is rated Start-class on Wikipedia's content assessment scale. It is of interest to the following WikiProjects:

Electronics Low‑importance This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles Low This article has been rated as Low-importance on the project's importance scale.

Djpark0115 (talk) 07:00, 21 May 2009 (UTC) Q^-1 is necessary in the encoder/ecoder diagram of option2 ??[reply]

Yes, good catch; it's needed in the type 2 encoder as well. Maybe you can alert the editor who made the figure... Dicklyon (talk) 17:19, 21 May 2009 (UTC)[reply]

Q^-1 is horribly wrong! Quantization is not invertible. Option 1 is only possible if no quantization is done and the compression algorithm is lossless. The whole article has a lot of errors. — Preceding unsigned comment added by 188.155.108.64 (talk • contribs)

You were right to remove the bad figure from option 1. I edited the text to make it correct, I think. Dicklyon (talk) 18:07, 8 January 2011 (UTC)[reply]